Nowadays, the laser cutting machine is a high-power heavy-duty equipment, its good play to make the subsequent work more smoothly, but also reduce costs. So in the operation of the middle must pay attention to, and usually pay attention to the maintenance and maintenance in order to increase the service life of the equipment, cost savings, to create greater benefits, to ensure good condition.

The quality and temperature of the circulating water directly affects the service life of the laser tube, it is recommended to use pure water, and control the water temperature below 35 degree C. If the temperature exceeds 35 degree C, it is necessary to replace the circulating water. If more than 35 degree need to replace the circulating water, or add ice to the water to reduce the water temperature, (recommended that users choose a cooler, or use two water tanks).

Cleaning the water tank: first of all, turn off the power, pull out the water inlet water pipe, let the water in the laser tube automatically flow into the water tank, open the water tank, take out the water pump, remove the dirt on the pump. Clean the water tank, replace the circulating water, restore the water pump back to the water tank, insert the water pipe connecting the water pump into the water inlet, and organize the joints. Energize the water pump alone and run it for 2-3 minutes (to fill the laser tube with circulating water).

(It is recommended to clean it before work every day, and the equipment must be in the state of shutdown) There are 3 reflective mirrors and 1 focusing mirror on the metal laser cutting machine, and the laser is reflected and focused by these mirrors and then launched from the laser head. The lens is easily stained with dust or other pollutants, resulting in laser loss or lens damage, No. 1 and No. 2 lenses do not need to remove when cleaning, just dip the cleaning solution of the mirror paper carefully along the center of the lens to the edge of the rotating wipe. 3 lens and focusing mirror need to be taken out of the mirror frame, with the same method of wiping, wipe the same after the completion of the load back to the original can be.

1. The lenses should be wiped gently without damaging the surface coating.

2. The wiping process should be held lightly to prevent falling; motion system in the work for a period of time, the movement of the joints of the screws, couplings will produce loosening, will affect the smoothness of mechanical movement, so in the operation of the machine to observe the transmission components there is no rattling or anomalies, found that the problem should be strengthened and maintained in a timely manner.